How to replace wiper blades

Before replacement

• After opening the package, check that the wiper rubber of this product has not come off and that there are no deformed or missing parts.
• Stop the engine and make sure the wiper switch is OFF.
• Remove traffic film and dirt from the glass beforehand.
• Please work on the glass and body with a soft cloth or similar material to prevent scratches.

How to replace

1. STEP 01

   Stand the arm up.

   Stand the wiper arm up and tilt the blade slightly so that the wiper rubber faces upward.

   • For retractable arms, refer to the work instructions in the car manual before proceeding.

   

2. STEP 02

   Remove the blade.

   Slide the wiper blade while pressing the stopper to remove it.

   How to remove cover type

   Raise the cover section and slide off the wiper blade.

   

3. STEP 03

   Install new blades and you are done.

   Slide the clip into the U-shaped hook on the wiper arm until it clicks into place.

   • After installation, operate the wipers approximately 10 times to confirm that they are properly installed and that there is no contact with the body or other parts of the vehicle.